1. Set up the movable shaft and conveyor belt roll. On the transformer core of our conveyor belt roll, put on the theme movable shaft that can be dexterously turned, and roll the belt on it.
2. When the conveyor belt roll is guided, be careful not to place hanging objects. In work sites that are not suitable for release, the conveyor belt roll can be guided first, and the nylon conveyor belt at the expansion and contraction point has a large radius of curvature. How to do it is to prevent damage to the nylon conveyor belt, and the expansion part discourages placing hanging objects on the nylon conveyor belt.
3. Replace it with a conveyor belt and it can be taken off at one time. If it is replaced with a conveyor belt, the new belt can be combined with the old belt, and the unloading belt can be carried out together with the new nylon conveyor belt of the machinery and equipment.
4. To prevent falling failure. For the transport aircraft in the level work, the old transport aircraft can be blocked at all points. For conveyors operating in an oblique azimuth, a blocking point must be selected to prevent failure due to weight drop.
5. Avoid extrusion when pulling the belt. After placing the position of the new belt of the conveyor, fix one side of the tape with a clamp, and then bypass the roller to connect with the rope of the eccentric wheel, and go through the traction belt machinery and equipment to evenly support the polyester EP conveyor belt. In the transport plane. When pulling the belt, prevent the large inclination conveyor belt and the sound card frame from extruding each other.
6. Fix it with fixtures. Fix one side of the textured conveyor belt on the transport sound card rack with clamps, and tighten the other end through a moving pulley until the textured conveyor belt does not relax more on the home roller.
7. Maintain proper spacing between the tensioning machinery and equipment, and fix the tensioning machinery and equipment at a distance of 100~130mm from the end point.
