The Industrial Rubber V-belts are annular tapes with a trapezoidal cross section (mainly using the frictional transmission force between the two sides of the belt body and the wheel groove)
Production Type | Top Width | Pitch Width | Height | Angle | Length | Length | Length | Length Mark |
Conversion | Range(inch) | Range(mm) | ||||||
Z | 10 | 8.5 | 6 | 40° | Li=Ld-22 | 13"-196" | 330-4978 | Li |
A | 13 | 11.0 | 8 | 40° | Li=Ld-30 | 14"-315" | 356-8001 | Li |
AB | 15 | 12.5 | 9 | 40° | Li=Ld-35 | 47"-394" | 1194-10008 | Li |
B | 17 | 14.0 | 11 | 40° | Li=Ld-40 | 19''-587' | 483-14910 | Li |
BC | 20 | 17.0 | 12.5 | 40° | Li=Ld-48 | 47''-394'' | 1194-10008 | Li |
C | 22 | 19.0 | 14 | 40° | Li=Ld-58 | 29''-708'' | 737-17983 | Li |
CD | 25 | 21.0 | 16 | 40° | Li=Ld-61 | 47''-394'' | 1194-10008 | Li |
D | 32 | 27.0 | 19 | 40° | Li=Ld-75 | 63''-825'' | 1600-20955 | Li |
E | 38 | 32.0 | 23 | 40° | Li=Ld-80 | 118''-825'' | 2997-20955 | Li |
F | 50 | 42.5 | 30 | 40° | Li=Ld-158 | 177''-825'' | 4496-20955 | Li |
3L | 9.8 | / | 5.6 | 40° | / | / | / | / |
4L | 12.7 | / | 8 | 40° | / | / | / | / |
5L | 16.8 | / | 10.5 | 40° | / | / | / | / |
Features
The Industrial Rubber V-belts are annular tapes with a trapezoidal cross section (mainly using the frictional transmission force between the two sides of the belt body and the wheel groove), which is widely used in industry, oil fields, agricultural machinery, textiles, steam turbines, electric motors and general power transmission.
Display
Marking
Industrial Rubber V-belts with high load,low elongation and long service life.
Structure
The structure of the Industrial Rubber V-belts consists of four parts: cloth, top rubber, tensile body and bottom rubber. The V-belt with the rope core structure is convenient to manufacture, the tensile strength is general, the price is low, and it is widely used. The Industrial Rubber V-belt with the special core structure has good toughness and high strength, and is suitable for high speed occasions. Most of the belt cores are cord belt cores, and a few of them are cord belt cores. Since these two core structures are fiber twisted or woven, the inter-fiber shearing during the operation of the Industrial Rubber V-belt causes the core to gradually break and elongate. Therefore, ordinary V-belts produced with cord and cord cores can only be used in low-load transmission systems.
Hot Tags: industrial rubber v-belts, China, manufacturers, suppliers, factory, wholesale, Raw Edge Plain, Car Timing Belt, Car Engine Timing Belt, Drive V Belt, Polyester Mesh Conveyor Belts, Ribbed Belt
Previous: Drive Belts
May 10, 2021
May 10, 2021